® Daisy Chain HD System GTB-HD-DCS GTB-HD-DCSP GTB-HD-DCR User Manualwww.gefentoolbox.com
6INTRODUCTION54542112673376BackFrontTopSplitter Unit Layout
7Splitter Unit Descriptions1 HDMI OutConnect an HDTV display to this HDMI port using an HDMI cable. 2 Pwr This LED indicator will glow bright blue w
8INTRODUCTION665421178233 5487BackFrontTopReceiver Unit Layout
9INTRODUCTIONReceiver Unit Descriptions1 HDMI OutConnect an HDTV display (or other HDMI device such as an A/V splitter or switcher) to this HDMI port
10CONNECTING THE DAISY CHAIN HD SYSTEM1. Connect a Hi-Def source to the Sender unit using the included HDMI cable. The Daisy Chain HD System can be
11CONNECTING THE DAISY CHAIN HD SYSTEM 3. Additional displays can be connected to the Splitter units (if used) by connecting an HDMI cab
12The maximum number of levels of Splitter and/or Receiver units that can be connected within the Daisy Chain HD System is dependent upon how each uni
13The Link LED indicators on the Sender, Splitter, and Receiver unit provide basic information on the current status of the Daisy Chain HD System.Cond
14OPERATING THE DAISY CHAIN HD SYSTEM The default EDIDThe Sender unit contains a default EDID which supports the following:Color Depths Audio Samplin
15EDID Programming Procedure 1. Make sure that the display (or other A/V device) is connected to the Receiver unit and that all other Receiver / Spl
16 If the EDID is identical to the EDID that was just programmed, “EDID the same as host” will be displayed on the screen. How the E
17OPERATING THE DAISY CHAIN HD SYSTEM The Hi-Def source can be controlled from the viewing location by connecting an IR Extender (Gefen part no. EXT-
18OPERATING THE DAISY CHAIN HD SYSTEMDetermining the current ModeThe EDID switch on the Daisy Chain HD System has two functions: 1) Fetch the downstr
19OPERATING THE DAISY CHAIN HD SYSTEMDefault Settings for the Daisy Chain HD SystemWhen the Daisy Chain HD System is unpacked from the box, the unit w
204. Type the following at the boot# prompt: socat5 b 115200 19200 5. Press the [ENTER] key. The following information will be displa
21OPERATING THE DAISY CHAIN HD SYSTEMDiagram showing RS-232 control using Broadcast Mode 1. Launch a terminal-emulation program (e
22Before setting unicast mode, it is important to identify the RS-232 device in the system with which the computer will be communicating. We will use
23 One distinct difference in typing the command line for unicast mode, is that the ID and depth of the unit must be specied. In b
24OPERATING THE DAISY CHAIN HD SYSTEM The diagram below illustrates how RS-232 commands (black arrows) from the computer (RS-232 con
25RS-232 SERIAL INTERFACEDE-9 Connector (Sender / Splitter / Receiver) Only TXD, RXD, and GND are used.RS-232 SettingsBaud rate ...
ASKING FOR ASSISTANCERev A1Technical Support:Telephone (818) 772-9100 (800) 545-6900Fax (818) 772-9120 Technical Support Hours:8:00 AM to
261 2 3 4 5 6 7 8Gefen recommends the TIA/EIA-568-B wiring option. Please adhere to the table below when eld terminating cable for use with Gefen pr
27SURFACE MOUNTING INSTRUCTIONSThe GefenToolbox Daisy Chain HD System should be mounted vertically on a wall or inside / outside a cabinet with wood /
28SPECIFICATIONSMaximum Pixel Clock...225 MHzVideo Input
29WARRANTYGefen warrants the equipment it manufactures to be free from defects in material and workmanship.If equipment fails because of such defects
Rev A120600 Nordhoff St., Chatsworth CA 913111-800-545-6900 818-772-9100 fax: 818-772-9120www.gefentoolbox.com [email protected]
CONTENTSINTRODUCTION...1 Operating N
1INTRODUCTIONCongratulations on your purchase of the Daisy Chain HD System. Your complete satisfaction is very important to us. About GefenWe special
2READ THESE NOTES BEFORE INSTALLING OROPERATING THE DAISY CHAIN HD SYSTEM• CAT-5e or CAT-6 cables should not exceed 330 feet (100 meters).• Shielded
INTRODUCTION3HDMI Features Supported• Resolutions up to 1080p Full HD and 1920 x 1200 (WUXGA)• 12-bit Deep Color • x.v. Color• LPCM 7.1 Audio, Dol
Sender Unit Layout4INTRODUCTION55421167323 476BackFrontTop
Sender Unit Descriptions 1 HDMI InConnect a Hi-Def source to this HDMI port using an HDMI cable. 2 Pwr This LED indicator will glow bright blue when
Kommentare zu diesen Handbüchern